-
yes.... : )
-
Good morning fine people. Jamie I did not get your email.... ahh my address did change a year or so ago. Thank you very much for the offer..but I did just fix it. : ) The bumping it.. or pulling on the line while trying to twist the knob did not do anything. I was busy with other things and did not want to get to involved right now, but I thought I
-
Hi Jamie: Thanks guys.. I will check it out tomorrow.
-
Hey Tommy.. I did try bumping the switch.. the motor does run both ways.. but bumping the switch, did not seem to change it the feel at the lever. I can't say I tried it doing both at the same time. I could not reach the lever and the switch at the same time.. I will try that with my wife. and as you say it probably needs to be taken apart anyways
-
Hey Brian... [I hope I have remembered that correctly] yes you are correct. when I try to move the lever back to the lock position.. it won't move far enough.. it barely moves at all.
-
Hi everyone.. it has been some time since I was here. I went to use my winch for the first time in some time. I clicked to freespool, pulled the line out. Hooked it to the tree I was going to move, and then tried to re-engage it, and I could not.....!! As I said it has not been used in some time. but it has never been underwater.. not even close. Any
-
sorry to hi jack.. I have been away for sometime.. and I the forum has changed.. I want to start a new thread..and I can't see a way to do it. hammerhead. I did finally find what I wanted.. and have posted my question in a new thread..
-
Ok the second side is changed. This one took me 60 to 65 minutes. It felt much much better. Perhaps I am just not understanding the directions but it seems they are telling you to take apart more than you need. hmm now re-reading it, again. On the lower arm.. they want you to loosen the vehicle side and unhook and seperate the knuckle case side. I was
-
I was going to start a new thread, but that option does not seem to be showing up anywhere right now. I did buy my springs today. I was going to wait, but I guess I was motivated by the others that have changed theirs. Last week I received a spring compression tool for my birthday. This afternoon. I did replace one of the springs. I was probably close
-
I will probably not change them right away. My time and money are focused on another project at the moment. I will of course post feedback. Where Brian only has a little rub in more extreme conditions I figure the heavy dutier springs will get me back to that "spot:" Of course now I wonder if I should also lift the front a little, when I do